Originally Posted by
Pozidrive
Understand how the TR will stay where it is, supported by its own bearings. But wouldn't removing and replacing the hydraulic unit be complicated by the fit of the duplex bearing? However, this isn't really relevant to the incident.
No. Six nuts hold the actuator (servo, hyd unit) onto the gearbox. There’s the two nuts either end of the pitch control rod (shaft) and one bolt/ nut attaching the flying controls to the input/ feedback lever. 4 hydraulic pipe unions, and some electrical plugs. That’s it. Very straight forward.
The pitch control rod (shaft) just passes through the centre of the duplex bearing (which is part of the spider) when the actuator (servo, hyd unit) is fitted to the back of the gearbox.