Pozi, I`ll try to clarify a bit, p56 #1117; if you undo the nut at the `spider end’, and the gearbox back-plate, you should be able to remove the hyd. unit complete, leaving the t/r supported on the rotor mast, which has internal splines at its top-end #1102. The spider/slider have splines matching the mast-splines, but it is difficult to determine if there is a lock-nut at the end of the rotor mast as well. The pitch control rod must run through the piston to the feedback link, and the piston limits its travel at each end of the jack... That`s how I see it, unless anyone can produce a full cutaway drawing.