Airbus FltCtrl
 

Hello

I wonder what the circle with the cross in the middle, and the 2 +'es is called on the fltctrl schematic page? Down together with the Y/D and stuff...

thanks

Perhaps you could give the readership a better idea of what you are asking by specifying a type?

Check your books.

its called circle with a X and 2e:ok:

Dont worry about it. If it was important airbus would tell you. All you need to know is, it works well!

You can tell I am bored today! I do believe this symbol just indicates a summation of signals from the Yaw Damper and the Rudder Pedals/Rudder Trim before being sent to the rudder actuator.

Best Regards

Office Pest.

Thank you, I believe the last answer is sufficient! =)