A320 Ground Spoilers after landing.
 

Hi everyone...

Today something unusual happened: we were in a A321NEO and after disarming the spoilers, during the after landing flow, I noticed that the Ground Spoilers indication on the F/CTL page remained up... I can't remember seeing such situation before. I looked on the FCOM and couldn't find anything refering to this. We deployed the Spoilers, retracted them, and then the ground spoilers indication showed the ground spoilers as retracted.

Does anyone know what could have happened? No ECAM or other unusual cockpit indication were noticed...

One or both thrust reversers not closed?

Both stowed ! I had already vacated the runway when I spotted the ground spoilers up and I made sure that the THR Lever was not on REV range, I can even recall seeing the TLA moving on the EWD.... If I'm not wrong, If the culprit was the reversers, none of the spoilers would retract.

A mere technical possibility:

Side stick lateral displacement brings up F/CTL and if your knee caused that beyond just a little bit, the spoilers come up onside with the ailerons. Asymmetrical, of course.

Don't remember seeing a symmetrical one, nor any logic for that.

​​​​

Were the spoilers actually up on both wings, or was it just the SD page indication?

It's just an electrical switch. Didn't make contact properly on the first go, did on the second.

Possibly, while disarming the lever may have shifted slightly towards extend cancelling the retract command.

For those unaware, this observed HF behaviour led to a change of OEM SOP. Already many years now, disarming the spoilers and closing T.O./turnoff lights is done in clean conf.

Used to be right after selection of L/G UP in the same action flow. But extending spoilers at 20ft was just not very nice.

vilas

Tangentially related, but I’ve never understood why some folks make a fist and hammer the speed brake lever to disarm it. Seems like they’re just damaging whatever switch is down there.

Human factor! May be some like to give a personal touch.

Hi there everyone... Tks for the replies !

I'm genttle with the speedbrake lever, there's even a video on Airbus Win discussing this topic (hammering it).Anyway, I don't know what could happened, probably some glitch god knows where down the path between the lever and the actual surface...

Check Airman

Yeah, what is with that? We aren’t at the same airline so, like Vilas said, that is some human factors thingy going on.

Using that “technique” after takeoff, I have seen a pilot partially deploy the SB’s.

A320251N

Hi, is there a link available to the video you’re referencing?

CaptainMongo

I’ve seen this happen too. It’s got to be one of the strangest things people do. Not sure why the think it’s necessary or ok.

Check Airman

Hi there !

Yes there is...

airbus-win.com/wp-content/uploads/2019/07/m122950_airbus_video-training_use-speedbrake-spoilers_04-06-19-sstt_100mo-2.mp4 (sorry for not posting the clickable url... the forum is not allowing me due to my reduced number of posts. Just add the www before it).

There's a pretty good amount of content in airbus win ! I highly recommend it.

Have a good one !

Airbuswin. What about the use of speed brake. This video explains the various possibilities.

They changed the procedure because of careless pilots who smashed the speed-brake lever down to disarm the spoilers. We had one aircraft where the speed brake handle was actually cracked. Such a shame the way some pilots treat the aircraft equipments. Same goes for the sliding table and the cockpit door. :ugh:

Edit: Found the photo.


https://cimg0.ibsrv.net/gimg/pprune....db93c4200.jpeg

OMG. Airbus is inthe air for so many years and it is still horrible and shocking to see, that many of the guys in the flightdeck still do not know or do not realize, that almost all of the handles are SWITCHES, but no (mechanically) LEVERS.
This is why they smash e.g. the spoilers, the landing gear etc pp. :ugh:
The outcome: see picture above from @pineteam

Geez... There's definitely some hidden anger in a guy/girl who smashes a lever like that. What about retarding the thrust levers like an animal, or pressing the brakes like there's no tommorrow for the brakes check?

So many possibilities :ugh:

Such a Shame...

Crazy. Completely agree about not smashing the thrust levers too. No need at all.

I will say that very gently disarming the speed-brake lever is silent and can be too subtle for PM to start the after-landing scan. Yes, if they look they can see that the spoilers have been disarmed, but they will be looking out to ensure safe taxi, and/or looking down to change frequencies, so might not notice straight away. The click from tapping the lever down is easily heard and gives PM an audio cue that they can do the scan as soon as able.

Note I am NOT advocating smashing the lever at all, just tapping it to generate a 'click' sound. What happened to the lever in that photo above is totally unacceptable.

After take-off is a different matter, triggered by a different cue. In that case, the lever can and should be gently pushed, to avoid inadvertent deployment, as stated by others.