|
Engine warmup
Engine warm up if shut down for less than two hours is 2 minutes at idle, if shutdown for more than two hours warmup is 5 minutes at idle.
Scenario: Engines have been shut down for 3 hours. Push back from gate, start both engines because it is required for initial taxi. After clear of congested area, shut down engine two (it has been running for less than 2 minutes) and continue taxi. What will be the warm up required upon restart of engine 2? |
Are you serious? Really?
|
He seems to be🤯 |
Originally Posted by CaptainMongo
(Post 10532265)
Engine warm up if shut down for less than two hours is 2 minutes at idle, if shutdown for more than two hours warmup is 5 minutes at idle.
Scenario: Engines have been shut down for 3 hours. Push back from gate, start both engines because it is required for initial taxi. After clear of congested area, shut down engine two (it has been running for less than 2 minutes) and continue taxi. What will be the warm up required upon restart of engine 2? |
Scenario: Engines have been shut down for 3 hours. Push back from gate, start both engines because it is required for initial taxi. After clear of congested area, shut down engine two (it has been running for less than 2 minutes) and continue taxi. What will be the warm up required upon restart of engine 2? |
Why not keep it running for 5 minutes and THEN assess whether you need to shut it down?!? Do you REALLY need to make things MORE complicated?!?
|
Ask yourself what you are trying to achieve - a warm engine prior to takeoff. If your manual states 5 minutes to warm up a “cold” engine, then unless you have run the engine for that long prior to shutting it down again, I’d suggest you start the warm up timer again on the next start. Be conservative. I would be a little suspect of the reason for shutting it down again so soon after pushback, hypothetical aside. |
What’s the increase in cost for nosewheel replacements ? |
OP, as You did not mention the type or general situation you are referring to, maybe You could write a few words on why a shutdown after clearing of the congested area is necessary or beneficial? Are you taxiing out for departure or are you referring to a mere relocation of the aircraft on the apron that is for whatever reason done under its own power and not by tug?
One thing that needs to be remembered as well is that not only fuel costs money, but so does an engine. A startup is not exactly easy on the engine and it may well be that the additional maintenance costs due to the number of startup/shutdown cycles racked up by this practice will be way larger than the possible fuel and brake wear savings... |
In case of a doubt, just be conservative: I will definitely go for the 5 min. 2 min more is not going to kill anyone. |
Originally Posted by B2N2
(Post 10532776)
What’s the increase in cost for nosewheel replacements ? |
Originally Posted by B2N2
(Post 10532776)
What’s the increase in cost for nosewheel replacements ? |
Several gate areas where we operate require a two engine taxi from the gate. After leaving the congested area, the taxi route can be 15 - 25 minutes, thus the engine shutdown. Monday I had a taxi which was 97 minutes gate to runway. How about a show of hands who would run two engines during that length of taxi. Once during that taxi we even shut down both engines for about 20 minutes, think of that. Then, to top it all off, we did a cross bleed to start number two. Our outfits bean counters have run the numbers and have determined any engine shutdown, regardless of length, is money saving. I fly airplanes, the bean counters count beans, if that’s what they have determined that’s good enough for me. To those of you who have provided a thoughtful response, thanks. |
I don't consider 20 minutes a long time at all. I'd keep them both running. Having the PTU or yellow pump running is incredibly annoying from a passenger perspective, particularly for those seated nearest to those pumps (A320).
Obviously for a 90 minute taxi at JFK, I'd consider shutting one down, but again, the noise in the cabin for that length of time may give me pause. If I know the taxi will be that long, I'll request extra fuel. We may be too heavy to make a SE taxi practical anyway. |
Get a tug to pull you out a bit.
According to a knowledgeable CFM gentleman, up to 15 minutes warmup is still beneficial to the longevity of the engine, which translates well into direct fuel savings due to low(er) burn for long(er) time. Though I understand you speak of IAE engines, which at least on the small bus really have a lot of ground idle thrust, pitty you cannot make it out on just one. Towards the core of your question, I have nothing to add. It is an odd situation hence you came here with it. The suggestion with a tug is serious - beancounter's business as you have already pointed out. |
I thought I posted this earlier, but it didn't show up so I'll risk repeating myself.
The bottom line is that running at/near idle for a few minutes then shutting down for 90 minutes does not meet the requirements for having a 'warm' engine. Perform a minimum of a five minute warmup. Setting takeoff power on an engine that isn't thermally stable is hard on the engine. The impact can be anything from a tip seal rub (permanent performance loss) to in extreme cases it can cause an engine surge. Saving a couple of gallons of fuel by not doing a proper warmup will be quickly swamped by even a small increase in engine fuel burn until the next overhaul. |
Originally Posted by tdracer
(Post 10533490)
I thought I posted this earlier, but it didn't show up so I'll risk repeating myself.
The bottom line is that running at/near idle for a few minutes then shutting down for 90 minutes does not meet the requirements for having a 'warm' engine. Perform a minimum of a five minute warmup. Setting takeoff power on an engine that isn't thermally stable is hard on the engine. The impact can be anything from a tip seal rub (permanent performance loss) to in extreme cases it can cause an engine surge. Saving a couple of gallons of fuel by not doing a proper warmup will be quickly swamped by even a small increase in engine fuel burn until the next overhaul. Thanks as always for your insightful contribution. I've flown with people who must pride themselves in applying takeoff thrust and shutting down the engine right at the limits. Never understood it. |
Mechanical sympathy applies. I once got to the staff carpark at the same time as a group of ground handlers. They obviously had some sort of private race going on, or were trying to beat the traffic. They each started their car engines and as soon as the engines caught, they all accelerated away like mad things. Every one of their engines sounded like a bucket of bolts, i.e. worn to buggery because of working the engines hard before the oil was warm enough to circulate fully. Now, think of a gas turbine engine, parts of which are under much higher stress than a car engine, especially at take-off power. As well as seals, and thermal stresses within the engine, the oil needs to be warm enough and fluid enough to get around the engine easily and quickly. |
Even at the risk of some thread drift:
Originally Posted by CaptainMongo
Monday I had a taxi which was 97 minutes gate to runway.
Surely, such a system would be desirable from an efficiency, fuel saving and engine lifetime saving standpoint and beneficient to ATC and airlines alike? If you are not going to depart for another 90 minutes, why not wait at some parking spot with, possibly a remote one, with ground power and aircondition plugged in? |
Originally Posted by CaptainMongo
(Post 10532265)
Engine warm up if shut down for less than two hours is 2 minutes at idle, if shutdown for more than two hours warmup is 5 minutes at idle.
Scenario: Engines have been shut down for 3 hours. Push back from gate, start both engines because it is required for initial taxi. After clear of congested area, shut down engine two (it has been running for less than 2 minutes) and continue taxi. What will be the warm up required upon restart of engine 2? |
| All times are GMT. The time now is 10:44. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.