|
CV Metropolitan
I went to the Helsinki aviation museum yesterday and there is a CV440. I noticed that it did not have deicing boots (quite surprised me) and surmised that hot air was used to antice the wing leading edge. The guide, a good egg, suggested I was wrong. Anyone here knows the definitive answer. Google suggests I am right. Maybe the Finnair ones were different. Not trying to be a pain, just interested. |
The Convair 240 certainly used a thermal (hot air) anticing system on both the wings and the tail surfaces, so it's likely that the 340 and 440 did too.
|
Yes it did use hot air,from the exhaust augmentors.I was doing a xAA acceptance airtest on a-440 and we had a discrepancy in the temp indicators during the anti-icing check,so it was turned off.Shortly afterwards,the compass system started to `wander`,so we quit and rtb`d.Upon selecting Flaps ,we had an asymmetric flap failure,so decided to land flapless(not covered in the Manual),put the gear down,2greens,none on left,same as flap,compass,anti-ice.Checked with 3rd crew member and Tower fly-by that gear was down,so flew a flapless touch &go,( as wheels come down rearwards),then a normal landing,shut down,,u/c pins put in ,went for coffee.Engineers called to hangar,shown a large hole in flaps,preventing extension,caused by the heating duct blowing,burning electrical wiring to burn,compass and a/indicators to fail.Rear spar was also damaged......
Con-Pilot(dcsd) also had a tale about CV anti-icing failure... "Hangar flying in a bar can save your life";` Accidents and close calls`-thread;16 July 2015..... |
| All times are GMT. The time now is 08:29. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.