B737 - Foot position braking after landing?
I'm trying to figure out what I'm doing wrong, sometimes not always when I brake after landing my legs just get tired and start shaking at the very end of the braking action, maybe it is because I leave my heel on the rudder pedal at the same time that I try to brake with the ball and toes of the feet? should I separate the heel from the pedal to make it easier to brake?
|
Don't skip leg day! Seriously though, maybe just wind the pedals a little closer, that may help. The aim is to keep your entire foot on the pedal.
|
Originally Posted by 321c
(Post 10304089)
I'm trying to figure out what I'm doing wrong, sometimes not always when I brake after landing my legs just get tired and start shaking at the very end of the braking action, maybe it is because I leave my heel on the rudder pedal at the same time that I try to brake with the ball and toes of the feet? should I separate the heel from the pedal to make it easier to brake?
|
Originally Posted by Flying Wild
(Post 10304843)
Use Autobrake instead? If your legs are shaking whilst braking the aircraft, you're definitely doing something wrong!
|
Or maybe you need to do some exercise :E Just kidding...
Seriously, it sounds your pedals are adjusted bit far away. |
Rudder pedals should be adjusted to allow you to ‘lock your leg’ straight out at the limit of rudder throw This allows adequate control in the engine out case and should provide for correct foot position in normal scenarios Rudder pedal position, seat height and fore/ aft adjustment to allow full, free control movement are three of the simplest but most important items to check every time you get in the cockpit, getting these right is a significant aid in accurate control in all phases of flight, take off and landing |
Hi 321c, try this: 1. Adjust the pedals so that you can comfortably apply full rudder deflection from your seated position. 2. When landing, ensure your heels are on the floor. 3. After touch down, while the auto brakes are doing their thing, slide your feet up so that the balls of your feet are near the tops of the pedals. 4. Braking application is markedly improved with less effort because of the increased leverage. However be careful and very gentle with the increased leverage. |
2. When landing, ensure your heels are on the floor. 3. After touch down, while the auto brakes are doing their thing, slide your feet up so that the balls of your feet are near the tops of the pedals. |
All times are GMT. The time now is 15:59. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.