Airline First Officer Crosswind Limitation
Hello,
So I searched a bit and can't seem to figure out the answer. My company's policy is a first officer may land if "Surface crosswind component does not exceed 15 kts;" Surface crosswind component.. I can't seem to find a precise definition.. is it the tower wind? (i.e. wind on the runway/wind sock/touchdown zone) or can the wind in the final from 1500ft AGL down be used as a limitation aswell? (i.e. the wind increases during the last 1500ft-1000ftAGL but at the rwy its the reported wind which is lower than the wind during final) |
Use whatever definition your airline tells you. Mine is 20 knots based on the tower reported wind.
|
I know that one airline uses the aircraft indicated wind at 50ft to record a FODA event when the FO is flying and the crosswind exceeds 15 knots... Sucks when the first officer knows how to slip :E
|
My airline says whats posted above.. I interpret as tower reported.. during final we have indicated wind higher than the first officers limitation? Should I just follow the tower's observation?
|
I would say if its reported grossly above 15 knots cross the captain should fly the approach... If its close, maybe wait for the wind reported together with the landing clearance.
|
I think it's the cruise wind component:)
Seriously? Your manual is quite clear: SURFACE WIND COMPONENT How else do you get the actual surface wind other than the tower report? But how can we know for sure, we don't even know which airline you work for. Ask your chief pilot. |
If the first officer is considered legally as second in command then presumably he would be certified competent at the end of his type rating to take off and land up to the aircraft limiting crosswind component. After all he has a command type rating - not a co-pilot type rating.
If the airline has a crosswind limitation for copilots, beyond which the captain must land, then clearly the airline does not trust the copilots training to type rating competency. Yet, in event of incapacitation of the captain, the second in command takes charge. Does that now mean he can safely land up to the maximum recommended cross-wind component? Methinks some inconsistency here. So now lets face the real truth. Either the type rating provider is not training the candidate on enough max component crosswind take off and landings to be safe but nevertheless slyly ticking the required box to keep the syllabus moving along. This is usually a cost aspect involved with extra simulator sessions. That is the most likely scenario. Or, the candidate simply is unable to consistently demonstrate the skill in the simulator to land in max crosswind components. If that is the case, the instructor could be sorely tempted to tick the box anyway rather than making waves by scrubbing the candidate as unable to reach required skill level. Especially if the candidate is self funding his own type rating. |
Never understood why FO's would have different wind limits. On the western edge of the Atlantic, FO's are only restricted for the first 100hrs. After that, you're allowed to use the full demonstrated crosswind.
|
Check Airman, I understand that your airline has no limits for FO's in the forst 100 hours, But when you fly with an FO who has 101 hours on type, do you allow him to land in a 38 knot crosswind? Or any other FO for that matter? When WOULD you take the landing fom an FO, if at all?
It's easy to say 'we don't have limits for FO's' but that puts responsability squarely on the shoulders of the captain. Some FO's I'd trust with any crosswind, purely because I have watched them land before in challenging conditions and know their abilities. Others...let's say I am happy that my airline wants me to take over at anything beyond 20 kts. I have no interest in finding about out my FO's talents during limiting conditions. |
Penko: Does a Captain with 1 hour in command automatically have a better ability to land in a crosswind? He has to get experience SOMEWHERE!
When the wind is above the FCOM or FOM limits, follow the rules. When within limits, make a reasoned decision based on current information. I've let FOs land in 30+ kt crosswinds, because I recognized their experience and abilities. That doesn't mean I didn't guard the controls, give a helpful hint or 2 on the way down, or have a hair trigger on a "Go around" command... For the OP, "surface wind" is that reported by AWOS, ATIS, or Tower. However, you also have to realize that if winds on the approach are significantly higher, you WILL run into a shear somewhere on the approach. |
But that's exactly my point. You say you respect their experience and ability but how do you know they have that experience and ability in the first place if you just met him or her for the first time in the crew room?
Surely you agree there is one big difference between a 1 HR captain and a random FO. |
If I just met him in the crew room for the first time, I would keep the PF role for the flight if there was adverse weather forecast.
There may or may not be a difference between a 1-hr Capt and a random FO. An FO may have just come to the company from another company where he flew the same airplane as a 1000-hr Captain... |
There may or may not be a difference between a 1-hr Capt and a random FO If it goes pear shaped it is his/her career on the line if no other consideration. |
I would think that the brief prior to the first flight would take care of the experience issue. Other side of the Atlantic might be different but as a U.S. legacy fo I've never had a captain take a leg based on conditions. Then again, to get hired here I was a captain at a previous airline with LCA experience and now close to 8000 hours on my type. Brief prior to flight pretty much covers all of that.
|
Penko,
If either crewmember has a concern about the conditions, it will be discussed. If one person isn't comfortable, the other will fly. Pretty simple. That said, the prevailing attitude here is that there's only one way to get comfortable landing in a 38kt xwind. (Hint, giving away those landings isn't it) I'm a new A320 FO (200hr on type), and I'm yet to see 38kt. The last time I had a reasonable xwind, the CA and I discussed techniques for xwind landings as part of the approach brief. At a prior company I flew with CA's who'd never seen a strong crosswind before, as they were new to the type. What would you do in that situation? Well one difference is that the Captain is responsible for the operation. If it goes pear shaped it is his/her career on the line if no other consideration. Some FO's I'd trust with any crosswind, purely because I have watched them land before in challenging conditions and know their abilities. |
At a prior company I flew with CA's who'd never seen a strong crosswind before, as they were new to the type. What would you do in that situation? If the first officer is considered legally as second in command then presumably he would be certified competent at the end of his type rating to take off and land up to the aircraft limiting crosswind component. After all he has a command type rating - not a co-pilot type rating. That suggests to me that it was not required under JAR/EU OPS and is not required under EASA. |
Sideline point - tower wind may be at various heights above ground. Further there is a reasonably pronounced shear gradient in the lower levels approaching the runway for a typical aerodrome.
A problem arises with the definition of where the wind is measured. One would prefer to see something along the lines of the operator's limit specifying "reported aerodrome wind" or similar. |
Tower wind should be measured always at the same height and there are regulations regarding it
|
Cak: Please tell us what that height is, and which regulations apply throughout the world.
|
From the ASOS (Automated Surface Observing System) Users Guide, Sec 3.2:
Before ASOS, airport wind sensors were generally exposed 20 feet above ground level. With modern, highperformance aircraft, this standard no longer applies. Now, current federal standards for siting meteorological equipment specify (with some variance permitted) a height of 10 meters (32.8 feet). Typical ASOS wind sensor heights are 33 feet or 27 feet, depending on local site-specific restrictions or requirements. |
ICOA, WMO, and FAA(NOAA) standards apply, as well as regional interpretations.
There is usually more than one sensor (anemometer) position, but all measure the wind velocity at the standard height of 10 meters above the surface. METAR Wind Velocity Wind velocity in a METAR is stated as the measured or estimated mean of each component over the 10 minutes prior to the time of issue of the METAR, unless there are significant variations during this 10 minute period. For direction, this means 60 degrees or more of arc but less than 180 degrees provided that the mean speed during the previous 10 minutes has been more than 3 knots. In the case of speed, variations from the mean wind speed (both above and below it) are reported when the variation from the mean speed has exceeded 10 kts. Such variations are expressed as the maximum and minimum speeds attained and must also be included if the maximum wind speed in a 10 minute period has exceeded the 2 minute average wind speed at the same location in that period. Any gust value which has occurred in the most recent two minute period will of course also be part of the calculation of average wind speed ATIS Wind Velocity ATIS wind velocity is latest two minute average. The wind direction broadcast is given in degrees true. The mean wind speed is supplemented by the value of the highest and lowest gusts within the 10 minutes prior to issue time if either exceeds the METAR-specified minimum difference increment away from the mean. ATIS broadcasts are usually only updated between the regular change times if the wind direction changes by more than 30 degrees or the 2 minute average wind speed changes by more than 5 kts over a five minute interval. ATC Wind Velocity Reports Display of wind velocity information to ATC at major airports usually allows at least the reporting by RTF of both the ‘average wind’ - that over a two minute period updated every minute - and ‘instant wind’ - the value at that exact time. The latter is usually used only where high wind speeds and their associated greater fluctuations in speed and direction prevail. |
Originally Posted by caber
(Post 9321968)
I would think that the brief prior to the first flight would take care of the experience issue.
|
Is not the objective in our industry and each of the flights we are in command of to achieve the highest level of safety reasonably possible?
Do not lower weather and wind authorizations for first officers new to the aircraft assist in that goal? Ofcourse if the Captains heart decides to MEL itself while he or she is in the lav, the first officer will have been awarded a "combat" promotion to Captain. But even then, I council my trainees the safety of the ship and her passengers out weigh landing at an unsuitable (for a new FO) airport. As a check airman, any FO I fly with is authorized to land up to AC demonstrated maximums, whether that FO has zero hours in the aircraft or 100 hours. Depending on the circumstance, I may or may not exercise that authority. It all comes down to the question, "Is what we are about to do advance the cause of safety?" After we have answerd that first question satisfactorily, we can go on to all the other ones. |
Originally Posted by A Squared
(Post 9326545)
Yes, because it's pretty common for FO's to inform a captain they just met that " I have XXXX hours, but really I'm pretty weak at crosswind landings."
Perhaps safety trumps ego to professionals. Try it sometime. |
All times are GMT. The time now is 23:59. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.