ADS-B How to turn it off without ....
 

Anybody know how I can turn off ADS-B (A330) [Assuming ATC request me to turn it off] without turning off the transponder?

My FCOM says refer to AIP but I can't find anything..

Quote from FCOM:
When the Air Traffic Controller requests to stop transmitting ADS-B OUT surveillance data or altitude (e.g. when she/he requests “STOP ADS-B TRANSMISSION” or “STOP ADS-B ALTITUDE TRANSMISSION”), do not switch off the ATC transponder or the altitude reporting, in order to maintain TCAS operations or Air Traffic Control radar surveillance and refer to Aeronautical
Information Publication (AIP) for alternate procedure.

You can't turn off ADS B without turning the txp to sby.
It's automatically part of the mode s txp and operates continually.


Are you sure they aren't referring to turn off the ADS C? It's part of the ATSU datalink and can be disarmed on the connection status page.

The only reference I can find to this rather unlikely scenario is:

"Requests to stop ADS-B transmissions shall only be made in the event of known or suspected airborne or ground system faults. In aircraft without pilot access to the ADS-B avionics, the pilot shall deactivate the ADS-B transponder in accordance with procedures approved by the aircraft operator. If this is not possible, advise ATC immediately."

http://legacy.icao.int/icao/en/ro/ap..._2003/wp04.pdf

Probably not worth losing any sleep over.

Definitely ADS B.

Yep it seems like a curly one. As you say probably not worth worrying about.

At least I can always simply advise ATC...

Thanks

On the bus there is no access to the ADS-B. If the transponder is on, it's on.

Wow thanks for re stating what I've already said :ugh:

I am not sure if this is helpful or not. The following is quoted from AC-20-165A which specifies a means of obtaining FAA approval for installation of ADS-B Out equipment:

In General Aviation, Garmin is a major provider of Mode S transponders with ES capability. They have a configuration setting that permits the pilot to turn off the ADS-B Out function. It is noted that it may only be used at ATC request. The AC 20-165A says this is not required, so I would not recommend setting the configuration to enable this feature for a General Aviation aircraft. I presume that the airline will or should provide information on how to deal with this issue. They still have more than 6 years to do this before the regulation kicks in.

Folks,
Nostalgia for the "good old days", when the transponder control panel had a mode select rotary switch with --- OFF,SBY,A,B,C,S. and maybe a separate ON/OFF switch for the altitude reporting function --- although I never did understand why you needed said ALT switch, given the ability to switch to A from C, and given that not all manufacturers panels had the ALT on/off.
Tootle pip!!

Beech---- the question related to the use of ADS B in the A330 and not in GA.
My Airline has been using ADS B ( and C ) for quite a while now. There won't be any further info coming out from them in regards to using it.
Also it is mandatory in Australia very soon ( in the next 12 months or so I think ) for all Airline Aircraft and not 6 years.

The only way to turn it off is switch the txpdr to sby. There are no controls or indicators relating to ADS B.

Sooner than you think nitpicker....

From 12 December 2013, all aircraft operating in Australian
airspace at or above FL 290 must carry approved, serviceable Automatic
Dependent Surveillance–Broadcast (ADS-B) avionics equipment