question about propeller and rpm
in my understanding
aoa of the propeller is the angle between the chord of propeller section and the relative airflow. but why would the forward speed become larger when the aoa is smaller? also what's the use of constant-speed unit? maintain constant speed? in the book it says csu is a "constant rpm system that permits pilot to select propeller speed, and therefore engine speed, needed for any situation". how could u have only one certain rpm but different airspeed and power? arent the airspeed and power increase directly to the an increase in rpm? dumb question i know :ugh: |
aoa of the propeller is the angle between the chord of propeller section and the relative airflow. but why would the forward speed become larger when the aoa is smaller? To explain a little more. I shall attempt to draw a picture with words. Draw an aerofoil section with an AoA with respect to its rotation and make the AoA very exagerated, i.e. more than the expected 4 or so degrees, probably about 20 degrees even more. Draw a line from the trailing edge of the aerofoil in line with the plane of rotation. Make the line at least twice as long as the aerofoil with the tip of the line extending out past the leading edge of the aerofoil. The length of the line represents the rotational speed of the prop. Next draw a very short line out at right angles to the tip of the rotation line, towards the aerofoil, this is the forward speed of the prop. Now draw a line from the tip of the short line back to the base (trailing edge of the aerofoil). You should now have completed a right angle triangle. The last line represents the relative airflow to the aerofoil or prop. If you know increase the length of the short line a slight amount to represent an increase in speed you should also see that the AoA has reduced. also what's the use of constant-speed unit? maintain constant speed? in the book it says csu is a "constant rpm system that permits pilot to select propeller speed, and therefore engine speed, needed for any situation". how could u have only one certain rpm but different airspeed and power? arent the airspeed and power increase directly to the an increase in rpm? The constant speed prop stops or minimises the AoA decrease that would occur when speed increases. RPM isn't the only factor regarding power. Power equals Torque X RPM. With a constant speed prop you can go faster by increasing manifold pressure (increasing torque) yet atill keep RPM constant. Hope my explanations help. |
Just imagine it as the gears in the car. Not the same but idea is similar.
|
All times are GMT. The time now is 13:15. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.