Trim setting?
Hi everyone! I'm just confused with another Airbus issue,
In the 737NG series trim is set manually, But yesterday I learned that the Airbus automatically sets trim for take-off. What I was precisely told was an aircraft taking off in CONF 3 sets the following; FMGC -> PERF -> TAKE OFF -> FLAPS/THS = 3/0 Is this correct? And if not and say the aircraft needed a take off trim of 2.6DN how would it be set in the FMGC e.g. what would be put in the FLAPS/THS option? Very much appreciated, Thanks! :) |
FMGC -> PERF -> TAKE OFF -> FLAPS/THS = 3/0 TO trim setting is achieved with FMGC input ZFWCG/ZFW. |
The Airbus does not set takeoff trim automatically, we have to set it. The value we enter in the Takeoff performance page is only there as a reminder.
TO trim setting is achieved with FMGC input ZFWCG/ZFW. The TOCG we have calculated by either using the Loadsheet (if you're in the dark ages) or the LPC is indeed entered like you say on the Takeoff Performance page, and in your example if you wanted 2.6DN and a Flap 3 takeoff you would put 3/2.6DN in the FMGC. As I said though this is only a reminder, so after engine start we would set 2.6DN using the trim wheel. |
The newest A330's in our fleet set the stab trim automatically during start.
This from FCOM 1 The THS is automatically set at 4 UP (inside the green band). Before departure, as soon as the three hydraulic systems are available, the THS is automatically set to the takeoff value, calculated by the PRIM, according to the ZFWCG entered in the MCDU and the fuel distribution |
On the A340 the trim is set automatically during engine start.
|
On the A340 the trim is set automatically during engine start. Toooo long ago;) |
Thanks for the replies everyone! :ok:
The Airbus does not set takeoff trim automatically, we have to set it. The value we enter in the Takeoff performance page is only there as a reminder. |
All times are GMT. The time now is 05:21. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.