PPRuNe Forums

PPRuNe Forums (https://www.pprune.org/)
-   Tech Log (https://www.pprune.org/tech-log-15/)
-   -   A320 Emergency Exit Availability (https://www.pprune.org/tech-log/362658-a320-emergency-exit-availability.html)

stezam65 17th Feb 2009 19:49

A320 Emergency Exit Availability
 
TO AIRBUS 319-320 PILOT AND CABIN CREW.

Dear Mrs. and Mr.,
in the rows adjacent overwing emergency exits of A319 and A320, the hooks that close passenger tables must be operated only inward. This is because during an emergency evacuation, the passengers cannot accidentally unlock the hooks and doing so permit no delay in airplane evacuation.

My first question is: can anybody give me any official Airbus document where is written that these hooks can be operated only inward?



In my airline the backrest of passenger seats of the rows adjacent emergengy exits (in all A319, A320, A321) reclines just a little bit comparing other backrests in other rows. This is because even if the backrest doesn't return in normal upright position, during an emergency evacuation the passenger flow's not delayed.

My second question: is there any official Airbus document where is written that these backrests must be limited in the recline?

Thanks a lot for any answer!
Stef

minstermineman 18th Feb 2009 17:28

Dont airlines select their own passenger cabin configurations / fittings - in which case it would have nothing to do with Airbus ? ?

Apart from that - it seems like common sense to me !

QA1 18th Feb 2009 19:02

Emergency Exit Access
 
An aircraft interior design layout has to be approved by the relevant airworthiness authority; for new European aircraft today that’s EASA. The requirements for accessing emergency exits for new designs are contained in CS25.813.

The A320 family of aircraft was certified to JAR 25 at change 11 (I think) – pre EASA. As a general guide for over-wing exits, the opening must not be restricted by anything, including loose table, reclined seats etc. hence the requirements you note.

UK CAA document CAP 747 has nice drawings and simple language under Generic Requirement No.3 for access to Type III and Type IV exits.

stezam65 18th Feb 2009 20:42

Thanks QA1
 
Dear Engineer,
thanks a lot for your help.
You gave me the correct informations I needed.
Just for anybodyelse info I paste all the pages concerning the data you gave me.
Thanks again. Grazie
Stef


http://www.caa.co.uk/docs/33/CAP747.PDF
pag.752.
To achieve, where possible, an orderly
approach to the exit from the aisle, the CAA has decided that the seat backs of those
seat rows immediately forward and aft of the exit access route from the aisle shall be
restricted in both recline and break forward not only to maintain the minimum access

width but also to maintain the seat back in an essentially upright attitude


Pag 755
The seat back of each seat which forms the boundary of the access route to each
Type III and Type IV emergency exit shall be restricted in its movement (break forward
and recline, where fitted) so as to maintain the minimum access to the exit required
by paragraph 4.1, and ensure that the seat back is in an essentially upright position
(i.e. fully forward or fully back, but not exceeding ±35° from the vertical), without

overlapping the projected opening of the exit





Pag 756
It is a requirement that fold-up meal tables are correctly stowed for take-off and
landing. If, however, having increased the seat pitch, particular seat back meal tables
are no longer used, they must either be removed from the seat, or their function
inhibited to ensure that they cannot inadvertently obstruct the access to the exit.
Where tables are retained for use at seats adjacent to the access route, the latches

shall be sufficiently reliable and adequately protected against inadvertent release



http://www.jaa.nl/publications/crd/jar-25-change13.pdf
pag. 142
For, aeroplanes that have a passenger seating configuration, excluding pilot's seats, of 20 or more, the projected opening of the exit provided may not be obstructed and there must be no interference in opening the exit by seats, berths, or other protrusions (including seat backs in any position) for a distance from that exit not less than the width of the narrowest passenger seat installed on the aeroplane


All times are GMT. The time now is 17:30.


Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.