Go Back  PPRuNe Forums > Flight Deck Forums > Tech Log
Reload this Page >

A320 - Feet position for taxi and TO

Tech Log The very best in practical technical discussion on the web

A320 - Feet position for taxi and TO

Old 8th Feb 2019, 04:04
  #1 (permalink)  
Thread Starter
 
Join Date: Dec 2016
Location: Asia
Posts: 51
Likes: 0
Received 0 Likes on 0 Posts
A320 - Feet position for taxi and TO

I couldn't find any reference in the FCOM/FCTM unless I missed it, but where does Airbus want our feet to be for Takeoff and Taxiing.

Fully on the pedals or heals on the floor?
slate100 is offline  
Old 8th Feb 2019, 04:43
  #2 (permalink)  
 
Join Date: Sep 2016
Location: Amongst the Gum Tree's
Posts: 90
Likes: 0
Received 0 Likes on 0 Posts
You put your left foot in, you put your left foot out, you put your left foot in.....

joke aside, you put them where directional and braking control is assured, common sense (I’m not a pilot)
QuarterInchSocket is offline  
Old 8th Feb 2019, 07:39
  #3 (permalink)  
 
Join Date: May 2004
Location: Ziltoidia... indeed'd.
Posts: 484
Likes: 0
Received 0 Likes on 0 Posts
Not in the FCOM, but keep in mind that under certain situations the pilot is required to maintain directional control through differential braking. This is best achieved by placing the full feet on the pedal and using the heels for directional control and the tips for braking.
iggy is offline  
Old 8th Feb 2019, 08:33
  #4 (permalink)  
 
Join Date: Jan 2012
Location: Home
Posts: 5
Likes: 0
Received 0 Likes on 0 Posts
Hi,

the FCTM PR-NP-SOP-70 says that one should be able to immediately and simultaneously apply full rudder deflection and full braking.
The way to achieve this is delegated to the individual operators as each have got their own view of this old time argument.
Nevertheless Airbus at one of its training conferences mentioned that their suggestion is for both pilots to keep feet up. The design of the pedals is such to have your whole feet resting on it.
try slide up you feet on that rubber material when landing on 38kt crosswind, or have an engine failure at low speed (below 72kt) on a 30m wide runway, good luck!
STFMD80 is offline  
Old 8th Feb 2019, 09:22
  #5 (permalink)  
 
Join Date: Jan 2014
Location: N5109.2W10.5
Posts: 720
Likes: 0
Received 0 Likes on 0 Posts
This is best achieved by placing the full feet on the pedal and using the heels for directional control and the tips for braking.
Oooo!
For take off, my heels were always on the floor to prevent inadvertent braking like these chaps.
https://www.nytimes.com/2011/11/03/w...y-players.html
https://assets.publishing.service.gov.uk/media/5423046f40f0b61342000b77/Gulfstream_G150__D-CKDM_12-11.pdf


Goldenrivett is offline  
Old 8th Feb 2019, 09:28
  #6 (permalink)  
 
Join Date: May 2004
Location: Ziltoidia... indeed'd.
Posts: 484
Likes: 0
Received 0 Likes on 0 Posts
If you need to reject and you have loss of braking on wet/slippery runway you will need to modulate braking pressure with the tips while maintaining directional control with the heels.

As I said, nothing written in the manuals, just my personal view.
iggy is offline  
Old 8th Feb 2019, 09:49
  #7 (permalink)  
 
Join Date: Aug 2012
Location: United Kingdom
Age: 34
Posts: 948
Likes: 0
Received 0 Likes on 0 Posts
Airbus doesn't specify as far as I'm aware, but talking to some of our training captain, I shifted from heels on the floor to heels up. The risk of brake application is minimal during TO if you keep your toes up, but needing to apply differential braking at max crosswind could be difficult otherwise. The time taken to shift heels up to the pedals in a heavy crosswind might be just the thing that puts you off the side of the runway. Same with max manual braking if needed.
Skornogr4phy is offline  
Old 8th Feb 2019, 11:35
  #8 (permalink)  
 
Join Date: Mar 2012
Location: Having a margarita on the beach
Posts: 2,402
Likes: 0
Received 0 Likes on 0 Posts
Check the Airbus CBT, You will see in lesson 1 the correct seating position including the proper positioning of feet on rudder, that is fully on the rudder, no heels on the floor.
sonicbum is offline  
Old 8th Feb 2019, 14:46
  #9 (permalink)  
 
Join Date: Nov 1998
Location: 🇬🇧🇪🇸
Posts: 2,094
Received 0 Likes on 0 Posts
I’m a heels on the floor man for take-off. It’s much easier to accurately control the yaw with rudder input after an engine failure above V1 if your heels are on the floor imho.
Nightstop is offline  
Old 8th Feb 2019, 18:45
  #10 (permalink)  
 
Join Date: Jul 2014
Location: UK
Posts: 21
Likes: 0
Received 0 Likes on 0 Posts
Originally Posted by Nightstop
I’m a heels on the floor man for take-off. It’s much easier to accurately control the yaw with rudder input after an engine failure above V1 if your heels are on the floor imho.
I concur. In the event of engine failure below 72kts, it only takes a fraction of a second to shift the feet up on the brakes.
Flaps0 is offline  
Old 8th Feb 2019, 20:12
  #11 (permalink)  
 
Join Date: Jan 1999
Location: UK
Posts: 36
Likes: 0
Received 0 Likes on 0 Posts
Originally Posted by Flaps0


I concur. In the event of engine failure below 72kts, it only takes a fraction of a second to shift the feet up on the brakes.
Not sure what 72kts has to do with it, is it 320thing? I have heard 80 kts on small jets and 100kts on bigger ones? We seem to have forgotten suprise and startle?
simufly is offline  
Old 8th Feb 2019, 20:30
  #12 (permalink)  
 
Join Date: Jul 2014
Location: UK
Posts: 21
Likes: 0
Received 0 Likes on 0 Posts
Originally Posted by simufly

Not sure what 72kts has to do with it, is it 320thing? I have heard 80 kts on small jets and 100kts on bigger ones? We seem to have forgotten suprise and startle?
A320 thing. Autobrake won’t activate if speed never exceeds 72 kts.
Flaps0 is offline  
Old 8th Feb 2019, 21:34
  #13 (permalink)  
 
Join Date: Sep 2010
Location: FL510
Posts: 81
Likes: 0
Received 0 Likes on 0 Posts
I did a Technical Request to Airbus a few months back regarding this.

XXX: My name,
ZZZ, ICAO Code of the airline I did the request for.

Dear XXX,

The following is in response to your message that is outlined below:

QUESTION:
We would like clarification on the recommended feet position during taxi, takeoff and landing.
FCTM PR-NP-SOP 70 P1/2 gives us informations but the wording is not very clear. Should the feet be on the rudder pedals or heels to the ground ?

ANSWER:
Airbus would like to inform ZZZ that as mentioned in ZZZ A320 Family FCTM PR-NP-SOP-70, the feet position has to ensure full rudder deflection combined with full braking, even in differential, can be applied instinctively and without delay.
As long as the above combined actions are met. Airbus does not have any specific recommendation on the where feet position should be.
We hope this satisfactorily responds to your request and we remain available for any additional information and assistance.

Best regards,



Valmont is offline  
Old 8th Feb 2019, 22:19
  #14 (permalink)  
 
Join Date: Feb 2000
Location: 500 miles from Chaikhosi, Yogistan
Posts: 4,282
Received 130 Likes on 59 Posts
Yes, I spoke in person to a couple of Airbus guys (and not sales reps/TREs...) about this at a conference and they confirmed that Airbus will never be so prescriptive to tell people where to put their feet, but the pilot must be able to apply full braking immediately without any delay. They unofficially verbally confirmed to me that the only way to achieve this is to have your toes on the brakes.
compressor stall is offline  
Old 8th Feb 2019, 22:39
  #15 (permalink)  
 
Join Date: Jan 2004
Location: Here and there
Posts: 3,089
Received 14 Likes on 11 Posts
I used to be heels on the floor. Having started flying an Airbus, I have changed my ways. The issue I find is that the pedals are grippy and I don’t find it easy sliding my feet up, particularly if I’m already holding some rudder in. I don’t particularly like it as it means I have to use my whole leg to move the rudder instead of just my toes which is what I was used to.
AerocatS2A is offline  
Old 9th Feb 2019, 00:23
  #16 (permalink)  
 
Join Date: Nov 2006
Location: Tropics
Posts: 359
Likes: 0
Received 0 Likes on 0 Posts
For those of you who have your heels on the floor for landing in strong crosswinds, how do you move your feet up when you want to transit to manual braking without releasing the pressure on the rudder pedal for a moment?
dream747 is offline  
Old 9th Feb 2019, 00:28
  #17 (permalink)  
 
Join Date: Aug 2005
Location: East of eden
Age: 79
Posts: 151
Likes: 0
Received 2 Likes on 1 Post
Less than 72 kts is not a killer speed so you have time to move your feet to apply brakes. Auto brakes and heels on the floor for me. I'm flown Airbus, BAe, Boeing , Gulfstream and McDonald Douglas with and without auto brake and regardless I'm always heels on floor. And I've rejected close to V1.
flown-it is offline  
Old 9th Feb 2019, 04:46
  #18 (permalink)  
 
Join Date: Apr 2004
Location: Planet Earth
Posts: 2,083
Likes: 0
Received 8 Likes on 7 Posts
Originally Posted by dream747
For those of you who have your heels on the floor for landing in strong crosswinds, how do you move your feet up when you want to transit to manual braking without releasing the pressure on the rudder pedal for a moment?


You shouldn’t have to release any, just carefully and smoothly slide your feet up the rudder pedals while keeping the same input until you can operate the brakes


Otherwise it’s heels on the floor, better for control and avoiding inadvertent brake application
stilton is offline  
Old 9th Feb 2019, 06:44
  #19 (permalink)  
 
Join Date: Jun 2006
Location: B.F.E.
Posts: 228
Likes: 0
Received 0 Likes on 0 Posts
Originally Posted by stilton




You shouldn’t have to release any, just carefully and smoothly slide your feet up the rudder pedals while keeping the same input until you can operate the brakes


Otherwise it’s heels on the floor, better for control and avoiding inadvertent brake application
Absolutely. Coming from Boeings and having flown for many years into a home airport where strong crosswinds are the standard, I agree that as long as a person has developed the exact technique you described, it works great. I use it. Maintain the exact position and pressure on the pedals for the crosswind correction, while sliding the feet the pedals to initiate even braking. The tricky bit with Airbus rudder pedals is that they are LONG. If your foot is not ALL the way to the top (your toe will hit the stop on the top of the pedal), your braking will be uneven. Folks coming from other types often don't realize they are not using the entire pedal, and that full brake deflection is not possible unless you do so. If you regularly land the Airbus and wonder why you always have to hold the pedals one side or another even in calm wind, or have one side brakes that always heat up more, check you foot position and feel for the stop all the way up on the top of the pedals next time. For the same reason, the angle of the pedal is somewhat different than other types, so it is difficult to inadvertently brake even if your heels are up.

In other words both techniques work. The key point is to use whichever one gives you best control at all times, which is more than likely dependent on past experience and the shape of your foot and flexibility in your ankles! The other key is to again, make sure that both feet are all the way up to the top of the pedals during manual braking.
hikoushi is offline  
Old 9th Feb 2019, 08:43
  #20 (permalink)  
 
Join Date: Jun 2007
Location: Wanderlust
Posts: 3,396
Likes: 0
Received 0 Likes on 0 Posts
Since speed for taxiing is slow it's not an issue, keep it up or down. For takeoff there is no recommended position. But in adverse conditions sliding the feet up for differential braking with full rudder in EFATO low speed reject can be a handful. In B747 classic rudders were not connected to nose wheel making very difficult. I always kept my feet on top and was very easy to slam the brake and rudder. In A320 with A/BRAKE and some control of nosewheel through rudders should not be difficult. As stated by Airbus as long as the objective to use full rudder deflection and differential braking can be achieved use any position you are comfortable with.
vilas is offline  

Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.