PPRuNe Forums - Search Results
PPRuNe Forums

Go Back  PPRuNe Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Wikiposts
Today's Posts
Search
Vendor Directory
Search: Posts Made By: aeromech3
Showing results 1 to 8 of 8
Search took 0.00 seconds.
Forum: Accidents and Close Calls
14th Mar 2024, 06:14
Replies: 57
Views: 18,492
Posted By aeromech3

Ref to the axle end in the picture, the number of...

Ref to the axle end in the picture, the number of threads visible would be quite normal, hence the axle nut is in the correct torqued position, hence most likely the spacer is still present, would...
Forum: Accidents and Close Calls
14th Mar 2024, 05:58
Replies: 57
Views: 18,492
Posted By aeromech3

The video's all show the axle intact and the...

The video's all show the axle intact and the inner bearing race and its outer track resting on the axle, only the wheel and outer race parts are missing.
No doubt as good practice the axle was...
Forum: Accidents and Close Calls
13th Mar 2024, 04:16
Replies: 57
Views: 18,492
Posted By aeromech3

In our small aircraft wheel shop, attached to my...

In our small aircraft wheel shop, attached to my last hangar set up, the specific greasing of the bearings was strictly applied and itemised on the wheel build sheets (preferred manufacturer had a...
Forum: Accidents and Close Calls
11th Mar 2024, 12:09
Replies: 57
Views: 18,492
Posted By aeromech3

Just seen Stig shift, I ignore his comments, as...

Just seen Stig shift, I ignore his comments, as far as I am concerned, if UA shop did the NDT or the bearing was over-loaded by torque or lack of grease or the wheel had been subject to very high...
Forum: Accidents and Close Calls
10th Mar 2024, 07:42
Replies: 57
Views: 18,492
Posted By aeromech3

C Q McHale, see my post #18, direction of this...

C Q McHale, see my post #18, direction of this inner wheel rotation, except during push-back, would tend to tighten the axle nut.
Forum: Accidents and Close Calls
9th Mar 2024, 02:31
Replies: 57
Views: 18,492
Posted By aeromech3

Just for info: Jacking a wide body airliner for...

Just for info: Jacking a wide body airliner for wheel change, if the tyre is flat a crocodile style jack is needed to get under the bogie (truck). The video shows the centre wheel change which is why...
Forum: Accidents and Close Calls
8th Mar 2024, 11:03
Replies: 57
Views: 18,492
Posted By aeromech3

MechEngr! The tenons of the rotors in the...

MechEngr!

The tenons of the rotors in the brake unit engage with the keys inside the wheel hub. The axle does not rotate with the wheel/tyre, heaven forbid. The axle nut with thick, sometimes...
Forum: Accidents and Close Calls
8th Mar 2024, 03:07
Replies: 57
Views: 18,492
Posted By aeromech3

General wheel knowledge with Boeing commercials. ...

General wheel knowledge with Boeing commercials.
If it was just the tyre then a wheel flange failure would be suspect ( nearly unheard of since detachable flange wheels have been phased out for...
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.