PPRuNe Forums - Search Results
PPRuNe Forums

Go Back  PPRuNe Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Wikiposts
Today's Posts
Search
Vendor Directory
Search: Posts Made By: RotarySpanner
Showing results 1 to 6 of 6
Search took 0.00 seconds.
Forum: Rotorheads
19th Oct 2012, 00:31
Replies: 11
Views: 2,262
Posted By RotarySpanner

Try swapping the dampers to see if the clock...

Try swapping the dampers to see if the clock angle changes for a start.

What work has been done to the blades while they were off?

Email Enstrom detailing everything you've done, they should be...
Forum: Rotorheads
29th Jun 2012, 00:07
Replies: 13
Views: 6,011
Posted By RotarySpanner

You need a copy of Lycomings Key Reprints in your life.

To my knowledge this is the 'official line' taken from the Key Reprints, found at:

Key Reprints - Lycoming (http://www.lycoming.com/support/tips-advice/key-reprints/index.html)


''Lycoming...
Forum: Rotorheads
7th Jun 2012, 00:29
Replies: 80
Views: 20,471
Posted By RotarySpanner

The Bell is built like a tank and weighs in like...

The Bell is built like a tank and weighs in like one because its composite technology is old. In some places the composite is over an inch thick and stuffed full of metal. Designed in an era to...
Forum: Rotorheads
29th May 2012, 20:02
Replies: 80
Views: 20,471
Posted By RotarySpanner

Ika - you are correct to be weary of parts...

Ika - you are correct to be weary of parts problems. I have seen lead times of over 2 years for certain bits. Not sure how larger companies get on, but certainly in my experience, the smaller...
Forum: Rotorheads
28th May 2012, 23:50
Replies: 80
Views: 20,471
Posted By RotarySpanner

If it was me, I'd get an early lightweight 206...

If it was me, I'd get an early lightweight 206 converted A, with good component times, run it a few hundred hours a year, then move on to a Longranger as and when I need a bit more room/better ride. ...
Forum: Rotorheads
19th Jan 2012, 19:09
Replies: 76
Views: 20,288
Posted By RotarySpanner

I'm an engineer, and although it would appear...

I'm an engineer, and although it would appear that I am new here, I have actually checked in on PPRuNe periodically over many years to tap into what can be very interesting and valuable industry...
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.