Another old lady gone....
https://aviation-safety.net/database...?id=20190121-0
With respect to the crew that did not survive. |
|
|
Originally Posted by cavuman1
(Post 10366780)
|
Turbo Dak crash OH, 2 fatalities
From ASN
The Douglas DC-3-65TP struck power lines, trees and impacted open field terrain under unknown circumstances to the southeast of Stoltzfus Airfield, in Wayne County, Ohio, USA. The aircraft was destroyed during the accident sequence and two occupants were fatally injured. Four others survived. |
Think it is possibly hydraulic fluid NOT blood.
|
The fuselage stayed relatively intact, how unfortunate that they have hit something to destroy the cockpit.
Just out of general interest what is the performance like of these turbine conversions on one engine? I used to fly a Turbine Islands, obviously considerably smaller, and when simulating engine failure during LPC and OPC checks it was very difficult to get it to climb. I suspect in the real world a genuine engine failure shortly after take off would have left me looking for somewhere to force land. |
|
Originally Posted by Council Van
(Post 10366947)
The fuselage stayed relatively intact, how unfortunate that they have hit something to destroy the cockpit.
Just out of general interest what is the performance like of these turbine conversions on one engine? I used to fly a Turbine Islands, obviously considerably smaller, and when simulating engine failure during LPC and OPC checks it was very difficult to get it to climb. I suspect in the real world a genuine engine failure shortly after take off would have left me looking for somewhere to force land. |
Originally Posted by iceman50
(Post 10366934)
Think it is possibly hydraulic fluid NOT blood.
Second picture is actually showing its sight gauge and what’s left of the flap and gear lever I guess |
Second picture is actually showing its sight gauge and what’s left of the flap and gear lever |
Single engine performance
Originally Posted by Council Van
(Post 10366947)
The fuselage stayed relatively intact, how unfortunate that they have hit something to destroy the cockpit.
Just out of general interest what is the performance like of these turbine conversions on one engine? I used to fly a Turbine Islands, obviously considerably smaller, and when simulating engine failure during LPC and OPC checks it was very difficult to get it to climb. I suspect in the real world a genuine engine failure shortly after take off would have left me looking for somewhere to force land. |
Freight
Originally Posted by Lodrun
(Post 10368210)
If there were only two crew on board, it should have been able to climb on one engine.
|
The thing with a conversion is that you need to keep about the same power as with the original engines so that the aircraft will behave similarly in an engine-out situation. If you went onto one much more powerful engine then the amount of control from the rudder would be quite insufficient. The Twin Otter, for example, limits the amount of power on the later versions of the PT-6 to that available on the original engine, for this reason.
One "gotcha" with this DC-3 conversion is that functioning autofeather is a required item, or so I have been told. Without it an engine failure immediately after lift-off can be a serious problem. |
Indeed, most twin turboprops will struggle following an engine failure and no autofeather. |
most if not all the large pistons had auto feather as well
|
Originally Posted by chuks
(Post 10368259)
The thing with a conversion is that you need to keep about the same power as with the original engines so that the aircraft will behave similarly in an engine-out situation. If you went onto one much more powerful engine then the amount of control from the rudder would be quite insufficient. The Twin Otter, for example, limits the amount of power on the later versions of the PT-6 to that available on the original engine, for this reason.
One "gotcha" with this DC-3 conversion is that functioning autofeather is a required item, or so I have been told. Without it an engine failure immediately after lift-off can be a serious problem. |
While it is not yet known if an engine failure was the cause of this accident, it is worth remembering that any delay before feathering the prop in a turbo prop aircraft means the drag from the windmilling prop is so great that airspeed and directional control would be lost in seconds. The DC3 has very small rudder pedals close together and it is not easy to apply full rudder especially against the drag from a windmilling prop.
In a similar accident many years ago in Australia where a piston powered DC-3 had a total engine failure at 200 feet after take off over water, the investigation found the PF used insufficient rudder against the windmilling prop and then applied almost full aileron to aid directional control until ditching a few seconds later. The full aileron caused significant drag. The initial combination of windmilling prop, less than optimum rudder and airspeed and full aileron, meant the DC-3 was never able to climb because of the amount of the drag involved. The captain feathered the propeller which stopped several degrees before the fully feathered position. By then its drag had reduced considerably. Fortunately, in the case of the ditching, everyone (27 people?) got out without serious injuries as the water was shallow. |
The thing with airplanes certified to older standards is that you do not necessarily have this modern transport aircraft capability of assured performance, when you can either stop or else go with an engine failure. That would be in any reasonably foreseeable case assuming that you operate within your performance limitations. With the Greasy Three there's often a little gap, but a very significant one, where you are probably going to come down with a thump if one of the donkeys quits. That gap lies between stopping safely and flying away.
There was one like that when I was working in Miami (which included a few hours as a right-seater on the DC-3), where a local hero lost one engine right after take-off, did a graceful pirouette, and crashed still abeam the runway. I understand that if that man's name had been Bob Hoover or Chuck Yeager then he might well have managed not to crash, but modern aircraft are certified for a pilot of normal ability to manage such a failure and get away with not crashing. Not the DC-3, however! I bet that a CV-580 is longer than a CV-440. If so, that would give a longer arm for the rudder, no? That or else that the Allison engines are de-rated for takeoff. Generally, you can not simply hang souped-up engines on an old twin engine airframe and be good to go. You get into certification problems that way because of Vmc and all that sort of thing. According to Wikipedia the Basler Turbo BT-67 uses PT-6A-67 engines that produce 1220 hp. The original Pratt & Whitney R-1830 Twin Wasp produces 1200 hp. Where you often get the big gains through re-engining is with flat-rating, the extra thermal horsepower coming into play as you climb. Too, a turbo-prop is generally much more dependable than an old radial engine, because of design and age issues. We used to get these guys coming up to the cockpit on the DC-3 as we were rumbling along at 3,500 feet, heading out to some island in the Bahamas. They would burble on about the romance, how this was "real flying" and all that hogwash, when I thought they should do a preflight on an R-1830 or R-1820 engine sometime and see how it leaks oil. (The joke with a radial is that if you see no oil leaks on the pre-flght, don't go flying; it is out of oil!) On a PT-6 I think it's one liter per ten hours, allowed oil consumption. On our DC-3 we would dump 5 gallons into each oil tank on turn-around out in the Bahamas when it was a long leg to Georgetown. Romantic, no so sure, but it certainly was sloppy! |
Originally Posted by chuks
(Post 10369334)
I bet that a CV-580 is longer than a CV-440. If so, that would give a longer arm for the rudder, no? That or else that the Allison engines are de-rated for takeoff.
|
Sad story if indeed the aircraft was going to another maintenance facility to have its engines checked... RIP to the crew.
In the initial reports and because of the US Government shutdown no one from the FAA or NTSB was going to be on sight to start the investigation. Does anyone know if this changed since the crash? |
Originally Posted by Jet Jockey A4
(Post 10369450)
Sad story if indeed the aircraft was going to another maintenance facility to have its engines checked... RIP to the crew.
In the initial reports and because of the US Government shutdown no one from the FAA or NTSB was going to be on sight to start the investigation. Does anyone know if this changed since the crash? |
Originally Posted by NTSB.gov
NTSB NewsLapse of AppropriationsDue to the lapse in appropriations and government shutdown, this website will no longer be updated. For more information on available government services, please visit USA.gov. Accidents still can be reported to the Response Operations Center at 202-314-6290. I would expect that "go teams" are on call for on-scene investigations of any major accidents which might occur, but with a severely reduced availability of support and administrative staff. That's just my guess though. As for any continuing work on in-process investigations, I doubt it. As well, any accidents which don't meet the threshold to be termed "major investigations" may be relegated to local authorities for preservation until such time as a field investigator becomes available. The breaking news right now is that the President has signed a bill to suspend the partial government shutdown for three weeks. How long it will take for NTSB to resume normal operations is unknown, but it's probably reasonable to expect a normal compliment of staff to show up for work on Monday? |
|
What's wrong with showing blood, for goodness' sake. We're all full of the stuff after all. Try working in a hospital. Or being a woman.
|
All times are GMT. The time now is 16:55. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.