New Cabri G2 helicopter crash - 2 persons injured
Thread Starter
Join Date: Jan 2019
Location: Approximately here
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
New Cabri G2 helicopter crash - 2 persons injured
A French newspaper reported a crash in the south part of the French alps, more precisely in Luberon.
It's mentioned that 2 people were in the helicopter. It has been reported that the aircraft was slightly spinning, and the 60 years old pilot was experienced and relatively injured while his wife was slightly injured.
Cabri G2 - SN 1170 - F-HRCR
Source: Helis.com
It's mentioned that 2 people were in the helicopter. It has been reported that the aircraft was slightly spinning, and the 60 years old pilot was experienced and relatively injured while his wife was slightly injured.
Cabri G2 - SN 1170 - F-HRCR
Source: Helis.com
Last edited by BDS29; 1st Feb 2019 at 07:47.
Previous Cabri accident
Would you see this as a fault, or safety feature?
Join Date: Aug 2002
Location: UK
Posts: 743
Likes: 0
Received 0 Likes
on
0 Posts
There do seem to have been rather a lot of G2 accidents in its ralatively short life. I appreciate that it is a purpose-built trainer so the risk factor is high, however to me, without having done any sort of in depth study, it seems a bit accident prone. This is a shame, as it is my machine of choice when I retire from full time 'paid' flying.
Does anyone have any accident stats in terms of accidents per 100,000 flying hours? Have there yet been any fatal accidents? It would be interesting to know.
JJ
Does anyone have any accident stats in terms of accidents per 100,000 flying hours? Have there yet been any fatal accidents? It would be interesting to know.
JJ
Join Date: Sep 2014
Location: N52.7 W2.04
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
I shall correct my post above. The basic message was that there were no GUIMBAL fatalities that could be linked in any way to the way it flies.
Join Date: Sep 2014
Location: N52.7 W2.04
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
Does anyone know how the BC Helicopters G2 which crashed during auto's training last November got on in relation to staying on top of its skids? From the write ups I have read, directional control was lost due to low NR and therefore low TR Speed making the fenestron ineffective, so if there were going to be forces to present to topple off of the skid cross tubes surely this would have been a "good" accident example to look at?
Look here, another picture a few posts down. G2 thread
Nothing magic about the G2, as it fills in more of the R22 role, you’ll see proportionally more accidents. From the report:
Nothing magic about the G2, as it fills in more of the R22 role, you’ll see proportionally more accidents. From the report:
Date Entered:
2019-01-25
Narrative:
Update TSB Report #A18P0169: C-GELP, a Helicopteres Guimbal Cabri G2 aircraft operated by British Columbia Helicopters, was conducting an autorotation training flight within the infield at Abbotsford (CYXX), BC with 1 instructor and 1 student on board. During the descent into the wind, the main rotor RPM decreased lower than anticipated. The Fenestron tail rotor became inefficient, and directional control was lost. As directional control was re-established in close proximity to the ground, the wind direction shifted, the helicopter skid tube contacted the ground and the helicopter rolled over. The instructor and the student exited the helicopter with minor injuries. The helicopter sustained substantial damage. The wind velocity at the time of the accident was 18 knots, gusting to 28 knots. There was no post impact fire.
2019-01-25
Narrative:
Update TSB Report #A18P0169: C-GELP, a Helicopteres Guimbal Cabri G2 aircraft operated by British Columbia Helicopters, was conducting an autorotation training flight within the infield at Abbotsford (CYXX), BC with 1 instructor and 1 student on board. During the descent into the wind, the main rotor RPM decreased lower than anticipated. The Fenestron tail rotor became inefficient, and directional control was lost. As directional control was re-established in close proximity to the ground, the wind direction shifted, the helicopter skid tube contacted the ground and the helicopter rolled over. The instructor and the student exited the helicopter with minor injuries. The helicopter sustained substantial damage. The wind velocity at the time of the accident was 18 knots, gusting to 28 knots. There was no post impact fire.
Last edited by malabo; 5th Feb 2019 at 01:35.
They all do that when there's a lateral impact.
https://resources.stuff.co.nz/conten...3560179344.jpg
https://cimg4.ibsrv.net/gimg/pprune....be0a4d9f21.jpg
To allow it to slide in a lateral impact.
In all cases where it's happened, the side of the cabin is on the floor. The cabin is usually always parallel to the floor.
Easier egress? Stabilises the wreck after a crash to prevent further flipping or spinning? I don't know.
Best guess is absorbing the energy of the crash.
The rate of left rotation is unknown, but markings on the ground indicate that there was a single impact and that the helicopter struck and rolled in place, with the rear portion of the landing gear embedded in the ground. The linear and angular momentum was absorbed by the landing gear, spreading the skids, with additional energy absorbed by the fuselage sliding across the skid tubes.
Surely it would be better to just design the skids to splay progressively on impact keeping the fuselage upright and preventing the rotors impacting the ground which is always going to be expensive to repair.
Originally Posted by [email protected]
Surely it would be better to just design the skids to splay progressively on impact keeping the fuselage upright and preventing the rotors impacting the ground which is always going to be expensive to repair.