Conversion of Non-EASA licences issued by States other than the UK
Hello Everyone
After reading CAP 804 Specifically Section 4 Part Q, Subpart 2 Page 5. C. ACCEPTANCE OF CLASS AND TYPE RATINGS (1) A valid class or type rating contained in a licence issued by a third country may be inserted in a Part-FCL licence provided that the applicant: (a) complies with the experience requirements and the prerequisites for the issue of the applicable type or class rating in accordance with Part-FCL; (b) passes the relevant skill test for the issue of the applicable type or class rating in accordance with Part-FCL; (c) is in current flying practice; (d) has no less than: (i) for aeroplane class ratings, 100 hours of flight experience as a pilot in that class; (ii) for aeroplane type ratings, 500 hours of flight experience as a pilot in that type; (iii) for single-engine helicopters with a maximum certificated take-off mass of up to 3 175 kg, 100 hours of flight experience as a pilot in that type; (iv) for all other helicopters, 350 hours of flight experience as a pilot in that type. I have an EASA CPL ME IR and ICAO CPL ME IR 737 type Rating My understanding after reading this is that after having 500 hours of experience on the 737 i could endorse that rating in my EASA license by doing an LPC. Is that correct? Can or should I wait to have the experience for the ATPL(A) and do one checkride for both purposes if that can be done?? Am I required to do the 6 or in this case 4 touch an go after the LPC?? Thank you all for the replies!! Aless. |
My understanding after reading this is that after having 500 hours of experience on the 737 i could endorse that rating in my EASA license by doing an LPC. Is that correct? |
Thanks for that Clarification on the Skill test!!
Any comments on the landings, are they mandatory?? and about the ATPL (A) Skill test, can I do both at the same time or have to be done separate? Regards. |
All times are GMT. The time now is 15:13. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.