Go Back  PPRuNe Forums > Aircrew Forums > Flying Instructors & Examiners
Reload this Page >

Powers and speeds for C182RG?

Wikiposts
Search

Notices
Flying Instructors & Examiners A place for instructors to communicate with one another because some of them get a bit tired of the attitude that instructing is the lowest form of aviation, as seems to prevail on some of the other forums!

Powers and speeds for C182RG?

Thread Tools
 
Search this Thread
 
Old 23rd April 2004 | 08:21
  #1 (permalink)  
Thread Starter
25 Anniversary
 
Joined: Jan 1999
Aviation Qualifications: CPL
Posts: 899
Likes: 42
From: Slowly decaying (disgracefully)
Powers and speeds for C182RG?

Someone has just asked for some IMC training in a C182 RG but I can't get my hands on the flight manual; can anyone advise on speeds and powers?
hugh flung_dung is offline  
Old 23rd April 2004 | 12:59
  #2 (permalink)  
 
Joined: Feb 2003
Posts: 376
Likes: 0
From: The Front of Beyond
H_F_D,

Sorry I don't have my check list with me, and can't remember the ones you'd want. If you can wait until this evening I can probably post some figure then.


Speeds and power setting from my check list:

C-182 RG operating speeds and power settings

Initial climb 90 knots 23" 2400 rpm
Cruise climb 120 knots 23" 2400 rpm
Cruise 140 knots 22" 2100 rpm
Cruise descent 140 knots 17" 2100 rpm
Hold 120 knots 18" 2100 rpm
ILS Localiser 120 knots 18" 2400 rpm
ILS Glideslope 100 knots 16" 2400 rpm

Hope this is what you wanted

Brooklands

Last edited by Brooklands; 23rd April 2004 at 21:16.
Brooklands is offline  
Old 28th April 2004 | 10:31
  #3 (permalink)  
Thread Starter
25 Anniversary
 
Joined: Jan 1999
Aviation Qualifications: CPL
Posts: 899
Likes: 42
From: Slowly decaying (disgracefully)
Thanks Brooklands, just what I needed!
Any other comments on operating the 182RG?

BTW, 'just found out it's an RG II - dunno yet what the difference is(?)

Isn't it refreshing to have a topic that doesn't lead to a heated debate
hugh flung_dung is offline  
Old 30th April 2004 | 15:42
  #4 (permalink)  
 
Joined: Feb 2003
Posts: 376
Likes: 0
From: The Front of Beyond
Hugh,

Here are some more useful numbers, and a few observations on flying the 182 RG. I'm assuming that you haven't flown a fixed gear 182 either. I'm not sure what if any the differenced are for a 182 RG II, but I don't expect that the speeds are significantly different.
Code:
V Speeds
                              Speed (Knots)  Flap setting Stall (full flap) Vso         37              40 Stall (clean) Vs1             42               0   Rotate (normal)               60               0   Rotate (short field)          47              20   Vat (normal)                  70              40   Vat (short field)             63              40   Vat (flapless)                75               0   Go around                     75              20   Vy                            88               0   Vx                            64               0   Max Glide (2550 lbs)          72               0   Max Glide (3100 lbs)          80               0   EFATO flapless                70               0   EFATO + flap                  65              40   Vfe                           95              20 - 40   Vfe                          140               0 - 10   Manoeuvring Speed (3100 Lbs) 112   Manoeuvring Speed (2550 Lbs) 101   Max demonstrated cross wind   18
One of the handy tips that I've picked up flying the 182 is to lower the first sage of flap when you lower the landing gear (the limit speeds are the same) - the trim changes pretty much cancel each other out, so you dont' need to retrim.

The 182 is pretty heavy in pitch, (especially compared to a 172) so it helps to keep it in trim. When you do a go-around you'll find you need a pretty hefty push on the control column to prevent her from pitching up too much.

Don't try to retract the gear as soon as you get airborne, wait until you're a few feet above the ground. Unlike low wing planes, the retraction mechanism on the 182 means that the initial movement of the wheels is DOWNWARDS.

Don't be tempted to approach too fast - there's a lot of wing, and it will float for ever given half a chance. Also don't close the throttle too early: try and keep some power on into the flare, as it helps with elevator authority - the 182 is rather nose heavy, and needs a good pull to stop it touching down nosewheel first.

Its one of my favorite planes: being one of the few four seaters that you really can get four people and a sensible ammount of fuel into. It will cruise at 140 knots, approach at 70, and has a very good short field performance.

Unlike the fixed gear 182s, which are fitted with a Continental O-470, the RGs have a Lycoming O-540 (derated to 235hp @ 2400rpm). NB the new build fixed gear 182s have an IO-540.

I should point out that with one excpetion I've only ever flown the 182 day VFR. And apologies if this comes into the "teaching granny to suck eggs" category.
Brooklands is offline  
Old 30th April 2004 | 16:49
  #5 (permalink)  
Thread Starter
25 Anniversary
 
Joined: Jan 1999
Aviation Qualifications: CPL
Posts: 899
Likes: 42
From: Slowly decaying (disgracefully)
Thanks again
I always insist that the gear is retracted only when there's insufficient runway remaining to land on. We had an interesting incident a few years ago when someone got airborne in a privately owned aircraft, retracted the gear VERY early and promptly sank onto the runway - expensive!
hugh flung_dung is offline  
Old 29th May 2004 | 13:56
  #6 (permalink)  
 
Joined: May 2004
Posts: 177
Likes: 0
From: london
good advice about raising the gear when you cant land ahead. applies to a lot of twins as well!!!!
whatunion is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.