PPRuNe Forums

PPRuNe Forums (https://www.pprune.org/)
-   Computer/Internet Issues & Troubleshooting (https://www.pprune.org/computer-internet-issues-troubleshooting-46/)
-   -   Netgear extender will not synch with Router (https://www.pprune.org/computer-internet-issues-troubleshooting/636692-netgear-extender-will-not-synch-router.html)

Pontius Navigator 10th November 2020 12:18

Netgear extender will not synch with Router
 
I have a Netgear EX2700 wifi range extender. It was working but after a power interrupt I can no longer synch with the Huawei Router. Power and WPS lamps are green Device lamp is off. I have tried both a wired connection with my laptop and a WPS connection when it is next to the router. I have tried a factory reset in both methods and it still fails to connect.

In the laptop connection, during setup, it finds the Router Network but fails to connect.

Netgear Community has some similar problems but there is no answers displayed. Can anyone suggest where to start?

Ancient Observer 10th November 2020 14:20

Could it be one of the "take it out of the socket and leave it for a few hours" (overnight) sorts of problems.??

My TP Link Powerline Adapters have required that in the past after a power interruption. They seem to behave themselves nowadays...................(cross fingers)

Pontius Navigator 10th November 2020 14:55

AO, no, it has been ongoing for a week or so. When plugged in it captures nearby devices but of course no internet connectivity so it is off more than on.

theFirstDave 10th November 2020 16:37

Have you checked in the Huawei Router settings, being able to specify an extender & enter the MAC address of it? Sometimes that works better then having the extender contact the router for them to sync up.

Pontius Navigator 12th November 2020 08:58


Originally Posted by theFirstDave (Post 10923526)
Have you checked in the Huawei Router settings, being able to specify an extender & enter the MAC address of it? Sometimes that works better then having the extender contact the router for them to sync up.

Thank you, I haven't ignored you, just the computer has been 'down' for a day with the latest MS update and is still flaky. I have the MAC but I might need some guidance IDC on following your advice. I will come back but I do.

Pontius Navigator 14th November 2020 17:43

I went into my Router settings and was able to find IP and MAC addresses for the devices but no idea how to enter this extender and its MAC. Any suggestions please.

jimjim1 15th November 2020 03:59

I would do a factory reset and set it up again.

Note same room suggestion for initial setup - but NOT TOO CLOSE. Say a few feet away or more. Manual seems pretty clear as these things go. Try WPS method first for sure.

https://www.downloads.netgear.com/fi...2700_UM_EN.pdf

Pontius Navigator 15th November 2020 10:38

Thank you. I had tried a factory reset twice, I shall give it one more go.

I must say I will not buy Netgear again, not because of this but their lack of free support over 90 days.


All times are GMT. The time now is 13:58.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.