Mode C verification
From a pilot can someone from ATC please confirm the tolerances for verification of mode C?
|
Originally Posted by fireflybob
(Post 9520133)
From a pilot can someone from ATC please confirm the tolerances for verification of mode C?
|
Tolerance for verification of Mode C is +/- 200ft |
At the risk of sounding like a pedant, it's worth pointing out that the +/- 200 ft does not reflect the pilot's (+/-100 ft) or aircraft's (differs based on date of manufacture) altitude keeping ability and only reflects the effects of altimetry and surveillance system errors. I say this only because I've heard some pilots discuss their belief that +/- 200 ft for SSR Mode C verification equates to their 'wriggle room' around a cleared level.
|
From ICAO doc 4444, as it may apply this way for other countries...
8.5.5.1 VERIFICATION OF LEVEL INFORMATION 8.5.5.1.1 The tolerance value used to determine that pressure-altitude-derived level information displayed to the controller is accurate shall be ±60 m (±200 ft) in RVSM airspace. In other airspace, it shall be ±90 m (±300 ft), except that the appropriate ATS authority may specify a smaller criterion, but not less than ±60 m (±200 ft), if this is found to be more practical. Geometric height information shall not be used for separation. |
All times are GMT. The time now is 21:50. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.