Wikiposts
Search
ATC Issues A place where pilots may enter the 'lions den' that is Air Traffic Control in complete safety and find out the answers to all those obscure topics which you always wanted to know the answer to but were afraid to ask.

Wake turbulence

Thread Tools
 
Search this Thread
 
Old 1st Nov 2016, 21:05
  #1 (permalink)  
Thread Starter
 
Join Date: Feb 2007
Location: UK
Posts: 83
Likes: 0
Received 0 Likes on 0 Posts
Wake turbulence

Greetings

Air taxiing helicopters on taxiways closer than 760m to the runway- does your unit apply any wake versus departures? How about a heli holding in the hover at an intermediate holding point next to the runway with a higher wake aircraft departure? (That rotates before said holding point?) all thoughts welcomed!
cottam approach is offline  
Old 1st Nov 2016, 23:21
  #2 (permalink)  
 
Join Date: Nov 2005
Location: Wildest Surrey
Age: 75
Posts: 10,813
Received 94 Likes on 67 Posts
Simply warn fixed wings of possible turbulence from the helicopter.
chevvron is offline  
Old 2nd Nov 2016, 00:29
  #3 (permalink)  
 
Join Date: Dec 2005
Location: Wellington,NZ
Age: 66
Posts: 1,676
Received 10 Likes on 4 Posts
And vice versa.
Most helicopter pilots, watching a heavy go past not far away, might elect to set it on the ground rather than maintain the hover. Or the pilot might elect to take his own wake turbulence separation and depart in a way that takes him clear of the wake.
Tarq57 is online now  
Old 2nd Nov 2016, 08:28
  #4 (permalink)  
Thread Starter
 
Join Date: Feb 2007
Location: UK
Posts: 83
Likes: 0
Received 0 Likes on 0 Posts
My question is specifically regarding light helicopters, think r22, operating in the hover or air taxiing adjacent a runway within 760m
cottam approach is offline  
Old 2nd Nov 2016, 15:46
  #5 (permalink)  
 
Join Date: Jun 2013
Location: Worthing
Age: 32
Posts: 22
Likes: 0
Received 0 Likes on 0 Posts
To put it simply. There are no requirements for wake turbulence to be mentioned, let alone seperation provided against a light heli. Though I have long believed that more research needs to be done to establish how rotor wash affects the air and subsequently other aircraft around it. We've all seen and read about incidents where aircraft have come a cropper, even behind a light.

I had an interesting chat with a pilot of a departin P28A which was climbing out parallel to a Jetranger using the adjacent heli circuit. Apparenly he almost lost all authority over the aircraft.
ATCO91 is offline  
Old 2nd Nov 2016, 20:45
  #6 (permalink)  
 
Join Date: Dec 2005
Location: Wellington,NZ
Age: 66
Posts: 1,676
Received 10 Likes on 4 Posts
Seems no-one is actually understanding the question.

I don't believe there is a requirement to provide separation. ICAO blithely seems to assume that taxiing aircraft are immune to wake, even if that taxiing takes the form of an airborne (IGE, low speed) manouever.

As I inferred above, warn the pilot of the light helicopter. He/she would hopefully set it down while waiting.
Tarq57 is online now  
Old 2nd Nov 2016, 22:22
  #7 (permalink)  
Thread Starter
 
Join Date: Feb 2007
Location: UK
Posts: 83
Likes: 0
Received 0 Likes on 0 Posts
Tarq57- correct and correct. I think your suggestion is pragmatic. I've trawled documents for guidance and there seems to be very little. There is mention of a helicopter crossing an active runway to be treated as an intermediate departure from that point, but no mention of said helicopter sat in the hover at a holding point whilst myriad or aircraft happily rotate before it. Are helis in the hover less vulnerable? Would you line up the heli straight after the departure, from the intermediate point and therefore into the wake, and have it wait for 3/4 mins for wake? Seems odd. My understanding is clearly off
cottam approach is offline  
Old 3rd Nov 2016, 05:50
  #8 (permalink)  
 
Join Date: Dec 2005
Location: Wellington,NZ
Age: 66
Posts: 1,676
Received 10 Likes on 4 Posts
No, I wouldn't.
I don't actually know if a helicopter in a low hover is more or less susceptible to wake from a heavy. I can't imagine it would be less susceptible, but at least it's not so far to fall.

I'd wait the full three minutes before lining it up, unless the pilot requested a waiver. That happens at my aerodrome quite a lot.
Tarq57 is online now  
Old 3rd Nov 2016, 06:48
  #9 (permalink)  
 
Join Date: Dec 1999
Location: LHR/EGLL
Age: 45
Posts: 4,392
Likes: 0
Received 0 Likes on 0 Posts
Cottam,

Our Heli aiming point is 250m from the edge of a nominal Code E runway, and is considered vortex independent from that runway, unless it's being used by an A380 (then 3 mins applies).

The taxiway some helicopters use to get to the HAP is only about 200m from the runway, but as we have been using it for hover taxying for years and years without incident, CAA were happy for us to continue using it as such. No wake separation is provided.
Gonzo is online now  
Old 3rd Nov 2016, 08:54
  #10 (permalink)  
 
Join Date: Jun 2013
Location: Worthing
Age: 32
Posts: 22
Likes: 0
Received 0 Likes on 0 Posts
I apologise I did misunderstand / misread the question. Where I work is quite a small airfield and no helicopter area is "wake" seperated from any runway and as such, any helicopters carrying out training within these areas are instructed to hold on the ground should an aircraft of a higher wake turbulence cat depart / go-around on the active runway.

The same goes for heli's hovering and awaiting a departure clearance.
ATCO91 is offline  
Old 3rd Nov 2016, 21:01
  #11 (permalink)  
 
Join Date: Jun 2013
Location: Róisín Dubh
Posts: 1,389
Received 11 Likes on 4 Posts
I haven't touched helicopter procedures since my original training but IIRC they're all to be treated as mediums for wake separation?
Una Due Tfc is offline  
Old 4th Nov 2016, 00:21
  #12 (permalink)  
 
Join Date: Jul 2005
Location: In the South !
Posts: 196
Likes: 0
Received 0 Likes on 0 Posts
Originally Posted by cottam approach
Greetings

Air taxiing helicopters on taxiways closer than 760m to the runway- does your unit apply any wake versus departures? How about a heli holding in the hover at an intermediate holding point next to the runway with a higher wake aircraft departure? (That rotates before said holding point?) all thoughts welcomed!
Guidance is scant in this regard; and unless authorised otherwise in unit MATs Part2 I would say, and we adopt, the only clear guidance which is the parallel runway 760m rule. Thus heavy landing all rotatories on the ground by 4 no later than 2 nm from touchdown and 2 mins for a dep. Caveat a departure crossing at a point before the nose wheel leaves the ground (no vortex) would be an acceptable alternate means of compliance.

Anecdotally I'm told that when a CH47 does a low approach and go-around and Gloucester the aerodrome effectively grinds to a halt for 3 mins.

With 2 relatively recent events of helicopters blowing over light GA aircraft it's a brave controller that doesn't treat wake turbulence TO helicopters and FROM helicopters with due regard.

Fred
ATCO Fred is offline  
Old 4th Nov 2016, 00:24
  #13 (permalink)  
 
Join Date: Jul 2005
Location: In the South !
Posts: 196
Likes: 0
Received 0 Likes on 0 Posts
Originally Posted by chevvron
Simply warn fixed wings of possible turbulence from the helicopter.
So you have a P28A landing with a Puma hovering 100 m from the runway edge and you think that's acceptable ??
ATCO Fred is offline  
Old 6th Nov 2016, 04:03
  #14 (permalink)  
 
Join Date: Mar 2014
Location: Way north
Age: 47
Posts: 497
Likes: 0
Received 0 Likes on 0 Posts
I once had a helicopter blowing onto the active because he was unable to stop it due strong tailwind. If he tried harder he would've chopped up the pavement on the taxiway with the tail rotor.
jmmoric is offline  
Old 10th Nov 2016, 10:19
  #15 (permalink)  
 
Join Date: Jul 2005
Location: se england
Posts: 75
Likes: 0
Received 0 Likes on 0 Posts
We are the 2nd busiest 'heli airport' in the uk and we apply wake turbulence to all lower category heli's air taxiing to the runway if a higher wake cat aircraft is using the runway. No part of the airport is more than 760m away from the runway so it sits on the ground for the required time. There is very little guidance in any publications so we go for the safest option.
no slots is offline  
Old 10th Nov 2016, 21:06
  #16 (permalink)  
 
Join Date: Mar 2014
Location: Way north
Age: 47
Posts: 497
Likes: 0
Received 0 Likes on 0 Posts
The guidance is between aircrafts departing, landing and making a low/missed approach opposite (oddly enough there's none stated if an aircraft is making a low/missed approach same direction) and an taxiing helicopter isn't departing og landing.

BUT that said, if we feel aircrafts will otherwise be affected by wakes, we have to inform them.
jmmoric is offline  
Old 10th Nov 2016, 21:20
  #17 (permalink)  
 
Join Date: Jan 2001
Location: Deepest darkest Inbredland....
Posts: 606
Likes: 0
Received 0 Likes on 0 Posts
However, not all pilots will request hover taxi, so you don't know if they are airborne or not.
terrain safe is online now  
Old 11th Nov 2016, 19:34
  #18 (permalink)  
Thread Starter
 
Join Date: Feb 2007
Location: UK
Posts: 83
Likes: 0
Received 0 Likes on 0 Posts
worrying how many people seem to have a different take on something that should be nailed down in the 493 (but clearly isn't).
cottam approach is offline  
Old 12th Nov 2016, 11:03
  #19 (permalink)  
 
Join Date: Sep 2008
Location: South West
Posts: 3
Likes: 0
Received 0 Likes on 0 Posts
Originally Posted by no slots
We are the 2nd busiest 'heli airport' in the uk and we apply wake turbulence to all lower category heli's air taxiing to the runway if a higher wake cat aircraft is using the runway. No part of the airport is more than 760m away from the runway so it sits on the ground for the required time. There is very little guidance in any publications so we go for the safest option.
As a matter of interest, does this feature in your MATS 2 or is it something that people just do?
zounds is offline  
Old 14th Nov 2016, 19:12
  #20 (permalink)  
 
Join Date: Mar 2001
Location: UK
Posts: 50
Likes: 0
Received 0 Likes on 0 Posts
Originally Posted by zounds
As a matter of interest, does this feature in your MATS 2 or is it something that people just do?
No need, it is our interpretation of the MATS PT1
stopbar is offline  


Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.