MD600N trim

[manuelMD600]

Hi , I cannot trim up on my MD600N , dual controls trim switches work perfectly lateral R/L and longitudinal Up , but when pressing down the breaker is popping out , is anybody experienced the same and can give me the findings ,

Thank you
Manuel

[md 600 driver]

Sounds like your trim motor has given up the ghost

[manuelMD600]

it works perfectly on lateral mode R/L ,and UP , I presume there are two electrical motors one for lateral mode and one for longitudinal mode ,so in my case Longitudinal works on down but breaker pops up when trimming up , problem on both sticks

[md 600 driver]

it works perfectly on lateral mode R/L ,and UP , I presume there are two electrical motors one for lateral mode and one for longitudinal mode ,so in my case Longitudinal works on down but breaker pops up when trimming up , problem on both sticks
you could ask your engineer to swop them over to test I think they are the same but check with your engineer

[manuelMD600]

Thankyou maintenance is coming to my field next week