Go Back  PPRuNe Forums > Flight Deck Forums > Accidents and Close Calls
Reload this Page >

SWA 737 overrun at BUR - Dec 6 2018

Accidents and Close Calls Discussion on accidents, close calls, and other unplanned aviation events, so we can learn from them, and be better pilots ourselves.

SWA 737 overrun at BUR - Dec 6 2018

Old 14th Dec 2018, 21:25
  #141 (permalink)  
 
Join Date: Aug 2000
Posts: 1,499
Likes: 0
Received 0 Likes on 0 Posts
Yes, I see that, but I said this with reference to the short and icy runway discussion.
Most of the time I’m not landing weight limited, so no need to go below the GS.
ManaAdaSystem is offline  
Old 14th Dec 2018, 21:57
  #142 (permalink)  
 
Join Date: Jan 2006
Location: Between a rock and a hard place
Posts: 1,262
Likes: 0
Received 0 Likes on 0 Posts
On my plane if the radar altimeter crosses the threshold at 50ft, the landing gear crosses at 22', so dipping 20 feet low and I will hit the runway edge lights. Don't flare long or reduce power too late.
The 737 radio altimeter reads 0 at touch down - i.e. distance between my sole and ground. I would have thought the same applied over the approach lights with slight variance for different deck angles, perhaps?
172_driver is offline  
Old 14th Dec 2018, 22:09
  #143 (permalink)  
 
Join Date: Dec 2014
Location: Nz
Posts: 431
Likes: 0
Received 12 Likes on 5 Posts
Only one foot variance.
Not sure what your ‘sole’ is but the gear is 15ft lower than your eyes when you are sitting in your seat with either flap 30 and 2.4 degree body angle or flap 40 and 1.4 degrees body angle.
73qanda is offline  
Old 14th Dec 2018, 23:23
  #144 (permalink)  
 
Join Date: Jan 2006
Location: Between a rock and a hard place
Posts: 1,262
Likes: 0
Received 0 Likes on 0 Posts
I meant bottom of my boots - i.e. my gear. When the "fifty" is called doesn't that mean my gear is 50 ft off the ground? Me sitting 15 ft higher is then 65ish ft up in the air.

I am not saying I have the answer - but I think the radio altimeter is calibrated to read distance between the wheels and the ground. Thus I am not going to drag my wheels through the approach light for being "a tad low on my RA",
172_driver is offline  
Old 15th Dec 2018, 00:26
  #145 (permalink)  
PJ2
 
Join Date: Mar 2003
Location: BC
Age: 76
Posts: 2,484
Received 0 Likes on 0 Posts
I meant bottom of my boots - i.e. my gear. When the "fifty" is called doesn't that mean my gear is 50 ft off the ground? Me sitting 15 ft higher is then 65ish ft up in the air.
I don't think so...



Also, 737 radio altimeters do not usually read '0' on the ground. The readings I've seen (in data) are in the -4 to -2 range.

The radio altimeter antennae are located just behind the EE-bay access door. The #2 RA Transmitter is first, then the #2 RA receiver, then the #1's in the same order.

Last edited by PJ2; 15th Dec 2018 at 00:58.
PJ2 is offline  
Old 15th Dec 2018, 00:29
  #146 (permalink)  
 
Join Date: Dec 2014
Location: Nz
Posts: 431
Likes: 0
Received 12 Likes on 5 Posts
When the "fifty" is called doesn't that mean my gear is 50 ft off the ground? Me sitting 15 ft higher is then 65ish ft up in the air.
On a standard ILS with a 50 ft TCH, the ILS antenna will cross the threshold at 50ft. The ILS antenna is about 3 feet in front of your chest and 15ft above the gear. The “fifty” call seems coincident with crossing the threshold in my experience.
73qanda is offline  
Old 15th Dec 2018, 00:56
  #147 (permalink)  
 
Join Date: Mar 2002
Location: Seat 1A
Posts: 8,532
Received 72 Likes on 41 Posts
172's question was related to the rad alt call, not the ILS TCH. Why would the rad alt call "50" if the wheels were only 35ft off the ground? In my jet (not 737), when it calls "5", I'm still in the air...
Capn Bloggs is offline  
Old 15th Dec 2018, 01:50
  #148 (permalink)  
PJ2
 
Join Date: Mar 2003
Location: BC
Age: 76
Posts: 2,484
Received 0 Likes on 0 Posts
RA calls are generated by the GPWC and may be pin-selectable (on/off). So far, the AMM isn't clear on the how the call is generated.
PJ2 is offline  
Old 15th Dec 2018, 02:03
  #149 (permalink)  
 
Join Date: Dec 2014
Location: Nz
Posts: 431
Likes: 0
Received 12 Likes on 5 Posts
Fair point.
I guess my question would be “ Does the rad alt call “fifty” when the rad alt is 50ft above ground? or does that rad alt call “ fifty”when the gear is 50ft above the ground?. I don’t think it calls it when the gear is at 50ft because it so often appears to call it exactly when we cross the threshold.
73qanda is offline  
Old 15th Dec 2018, 02:32
  #150 (permalink)  
 
Join Date: Jul 2000
Location: Jackson Hole, WY
Posts: 7,634
Likes: 0
Received 3 Likes on 3 Posts
Originally Posted by PJ2

Also, 737 radio altimeters do not usually read '0' on the ground. The readings I've seen (in data) are in the -4 to -2 range.
If you look, it’s always at 0 at wheel touch. The -2 is after strut compression.
737er is offline  
Old 15th Dec 2018, 02:41
  #151 (permalink)  
 
Join Date: Nov 2010
Age: 56
Posts: 945
Received 0 Likes on 0 Posts
Originally Posted by 73qanda
Fair point.
I guess my question would be “ Does the rad alt call “fifty” when the rad alt is 50ft above ground? or does that rad alt call “ fifty”when the gear is 50ft above the ground?. I don’t think it calls it when the gear is at 50ft because it so often appears to call it exactly when we cross the threshold.
50ft call is at 50ft Rad Alt. Based on the antenna position and body angle the gear will often be lower, as you can see from the picture in the previous post. In my airplane around 25ft lower.
hans brinker is offline  
Old 15th Dec 2018, 02:43
  #152 (permalink)  
 
Join Date: Nov 2010
Age: 56
Posts: 945
Received 0 Likes on 0 Posts
Originally Posted by ManaAdaSystem


Thanks, but I go below the GS when it is needed. On nornal landings I just follow the GS or PAPI.
Sorry, but it should never be needed. Either you have enough LDA to land in the touchdown zone, or you go somewhere else. Just because you haven't hit the runway lights doesn't make it ok.
hans brinker is offline  
Old 15th Dec 2018, 03:07
  #153 (permalink)  
 
Join Date: Mar 2015
Location: Fort Lauderdale
Posts: 42
Likes: 0
Received 0 Likes on 0 Posts
Anyone have access to 737-700 landing data? It would be interesting to see what the margins where. Even if legal it had to be pretty tight..
Reluctant Bus Driver is offline  
Old 15th Dec 2018, 03:17
  #154 (permalink)  
 
Join Date: Mar 2015
Location: Fort Lauderdale
Posts: 42
Likes: 0
Received 0 Likes on 0 Posts
As some have alluded to, the usable landing distance, assuming they did not go below GS, is 4575ft. Not much to hang your hat on..
Reluctant Bus Driver is offline  
Old 15th Dec 2018, 14:17
  #155 (permalink)  
 
Join Date: Aug 2000
Posts: 1,499
Likes: 0
Received 0 Likes on 0 Posts
Originally Posted by hans brinker
Sorry, but it should never be needed. Either you have enough LDA to land in the touchdown zone, or you go somewhere else. Just because you haven't hit the runway lights doesn't make it ok.
On paper I agree with you 100%. In real life I am very aware that braking action during winter operations is not an exact science. So, I add 100 - 200 m to the 12 m margin my calculations give me. I can pretty much guarantee that if you spent a few days in my cockpit to see what we do in the winter season on short, contaminated runways situated near high terrain, with moderate turbulence, snow showers, wind and 4 degree glide slopes... you would do the same.




ManaAdaSystem is offline  
Old 15th Dec 2018, 14:57
  #156 (permalink)  
 
Join Date: Aug 2000
Posts: 1,499
Likes: 0
Received 0 Likes on 0 Posts
Originally Posted by Reluctant Bus Driver
Anyone have access to 737-700 landing data? It would be interesting to see what the margins where. Even if legal it had to be pretty tight..
On a 5800 ft (1768 m) wet runway with 10 kts tailwind, 56 tons, my tool says he would need max autobrakes.
FL30 1409 m actual landing distance.
FL40 1380 m actual landing distance.



ManaAdaSystem is offline  
Old 15th Dec 2018, 15:18
  #157 (permalink)  
 
Join Date: Dec 2013
Location: US
Age: 66
Posts: 592
Likes: 0
Received 8 Likes on 4 Posts
Originally Posted by ManaAdaSystem


On a 5800 ft (1768 m) wet runway with 10 kts tailwind, 56 tons, my tool says he would need max autobrakes.
FL30 1409 m actual landing distance.
FL40 1380 m actual landing distance.



Were those numbers using fair braking action to account for the heavy rain?
Sailvi767 is offline  
Old 15th Dec 2018, 20:55
  #158 (permalink)  
 
Join Date: Aug 2000
Posts: 1,499
Likes: 0
Received 0 Likes on 0 Posts
Originally Posted by Sailvi767


Were those numbers using fair braking action to account for the heavy rain?
There are no options for «heavy rain» in my performance tool, and my calculations are based on our aircraft options. Which may or may not be the same as the SWA aircraft. I believe BA Good is used for a wet runway, however I have never had any braking problems on a wet and grooved runway.
India + Wet + Monsoon + Rain = a different story.
ManaAdaSystem is offline  
Old 15th Dec 2018, 20:57
  #159 (permalink)  
 
Join Date: Jan 2006
Location: Between a rock and a hard place
Posts: 1,262
Likes: 0
Received 0 Likes on 0 Posts
50ft call is at 50ft Rad Alt. Based on the antenna position and body angle the gear will often be lower, as you can see from the picture in the previous post. In my airplane around 25ft lower.
If the 50-call occurs at the exact moment the antenna is 50 ft off the ground, the lowest point of the landing gear would be at 25 feet. Yet touch down occurs as the radio altimeter reads 0. Something doesn't add up in my head......

Last edited by 172_driver; 15th Dec 2018 at 21:35.
172_driver is offline  
Old 16th Dec 2018, 02:52
  #160 (permalink)  
 
Join Date: Mar 2015
Location: Fort Lauderdale
Posts: 42
Likes: 0
Received 0 Likes on 0 Posts
Originally Posted by ManaAdaSystem


On a 5800 ft (1768 m) wet runway with 10 kts tailwind, 56 tons, my tool says he would need max autobrakes.
FL30 1409 m actual landing distance.
FL40 1380 m actual landing distance.



Usable glide slope landing length, assuming they did not go below, is 4575ft. Flap 40 actual landing distance is 1380m=4527ft. A legal margin of 48 ft? I am not trying to split hairs here, I am simply saying that looking at total runway length and equating it to legal landing distance is not correct. You have to look at available runway distance. It's an easy mistake. I know because I have made the same mistake, just not with consequences! On a razor thin margin like what happened in BUR it could be the difference between taxiing to the gate or ending up in the EMAS..
Reluctant Bus Driver is offline  

Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.